Self Filling Injection Devcie

Self Filling Injection Device

The Self Filling Injection Device allows the physician to accurately deliver a dosage of tumescent anesthesia or saline to a patient from an IV bag. The device uses single disposable 3 cc BD syringes and a single needle. The device eliminates the need for multiple syringes and needles. This helps to reduce the risk of accidental needle stick. The device comes with a protective holder that mounts on an IV pole. The holder helps to protect the physician from accidental needle stick and allows for mobility about the surgery room. It is common to inject tumescent anesthesia or saline multiple times over the course of a single hair transplant procedure. This device simplifies this process and minimizes accidental needle injury risk for the entire surgery team.

Self Filling Injection Device (SyroPumper)

Assembly procedures

- Remove the Dose Control Ring from the Guide pin.
- Remove or unscrew the Female Spring Guide from the Front Handle.
- The Front handle is separated.
- Install an 1/8 inch ID tubing on the Dual Check Valve.
- Open a BD 3 cc Syringe and insert the barrel in the Front Handle.
- Rotate the Barrel flange in the slot until it bottoms out against a stop pin.
- Insert the Female Spring Guide and the Guide pin in the.
- Tighten by threading the Female Spring Guide on the Front Handle.
- Install the Dose Control Ring on the Guide Pin and tighten screw. The position of the ring shall be adjusted based on the dose volume needed in the Syringe Barrel.
- Push the Syringe Plunger flange in the recess provided in the Back Handle, rotate the Lock plate around the plunger and lock the flange in place. Tighten the set screw.
- Assemble the Dual Check Valve on the distal end of the Syringe luer lock.
- Connect the inlet tube on the Dual Check Valve to the tubing from the IV bag.
- Connect a hypodermic needle to the luer on the front end of the Dual Check Valve.
- Ready for use.
- When the back handle is pushed against the Front Handle fluid is delivered through the needle assembly. When the Back Handle retracts by the spring force, fluid is sucked into the Syringe Barrel.

- To clean the spring and inside the spring box, remove the setscrew behind the Female Spring Guide. Both the spring and the male spring guides will come off readily. Clean, lubricate (for example with Miltex spray lube) and assemble back the units.

- After each use, the device is placed on a Safe Device (Pumper) Holder mounted on the IV pole. The needle is protected in the narrow slot. It is a one handed operation.

Customer Reviews: